HOW TO INSTALL

Step 1

The first thing to check is that the CLUG you got is the correct size for your tyre. All of the information is on the sizing page.

As a useful guide, we also put the maximum and minimum sizes for each CLUG right on the side of the packaging. Hold it up to the tyre and confirm that is is within the Clug’s range.

Measure up your Clug

Step 2

It’s time to work out where your CLUG is going on your wall. Holding your bike in the position you want it, position the CLUG where the tyre touches the wall.

You can then use the handy template on the box to get your hole spacing for the screws marked precisely.

Align your Clug

Step 3

FOR BRICK, CONCRETE AND STONE WALLS ONLY

You'll need to drill some holes if you are putting CLUG on anything other than wood surface (or a stud in the wall).

To drill, just stick your template lightly to the wall and drill right through the guide.

The box will help catch the dust too! We have thought of EVERYTHING!

Step 4

FOR BRICK, CONCRETE AND STONE WALLS ONLY

If you drilled holes, insert the wall plugs from your box into the holes to give you something to screw into.

Step 5

Separate the Clipper from the Gripper and screw the Clipper into the wall.

You'll be able to make small adjustments before you tighten the screws fully, to make sure that your CLUG is level.

Step 6

Snap the Gripper in to cover the screw heads, and you're ready to CLUG!

If you need to take it off again, don't worry, you can take the Gripper out to get to the screws. It takes a little force, but don't be afraid to stretch it a little. CLUG can take it!